How And Why To Clean a Shower Head
Jan 27, 2024
If your showerhead is producing a trickle of water, it may be necessary to cleanse it. Even water from a public supply can carry mineral deposits that accumulate and obstruct the apertures in the showerhead. This issue can become even more problematic if you reside in a region with hard water or employ well water.
Installing a quality shower filter can assist in minimizing mineral deposits and impurities. However, once the apertures, or nozzles, become obstructed, the showerhead becomes a conducive environment for the growth of bacteria and mold in its dark, damp, and warm interior. Unpleasant! It is time to gain knowledge on how to thoroughly cleanse your showerhead. By following the steps below, you might be enticed to exchange your tranquil bath for a rejuvenating shower.
How frequently should one attend to the cleansing of a shower head ?
If you have not yet attended to the cleaning of the shower head or if the water flow has diminished, it is imperative that prompt action be taken. Establish a recurring notification on your mobile device to diligently cleanse the shower head, ideally on a bi-monthly basis, or with increased frequency should you reside in an area plagued by the scourge of hard water. Consistent maintenance shall also serve to curtail the proliferation of mold and bacteria within the confines of the shower head.
How to Clean a Shower Head With Vinegar ?
Step 1: Populate Bag With Vinegar
Avail a plastic bag partially filled with distilled white vinegar. Exercise caution not to overfill the bag, as an excess could ensue when submerging the shower head.
Step 2: Envelop the Shower Head
Gently encase the shower head with the bag, immersing the entire fixture in the vinegar. If deemed necessary, adjust the vinegar level accordingly.
Step 3: Secure With a Rubber Band
Affix the bag securely with a rubber band or fastening ties ensnared around the neck of the shower head. Conduct a cautious assessment of the bag's stability to ensure it remains steadfast upon release. (Closing the shower door or drawing the curtain is recommended to contain any potential spills within the shower.)
Step 4: Immerse for Numerous Hours
Allow the shower head to immerse for several hours. For an exceedingly soiled fixture, an overnight immersion is advisable. If the shower head is brass, retrieve it from the vinegar after 30 minutes to prevent any detrimental effects on the finish. Additionally, abstain from this method on shower heads coated in nickel.
Step 5: Detach
Unfasten the bag and remove it from the shower head. Dispense the vinegar down the shower drain (consider incorporating baking soda to facilitate the elimination of soap scum buildup in the drain).
Step 6: Run Piping Hot Water
Permit piping hot water to flow through the shower head for a minute, effectively purging any mineral deposits lodged within the fixture.
Step 7: Clear Nozzles With a Toothpick
Utilize a toothpick or the pointed end of a paper clip to dislodge any clogged nozzles. Should any residue persist, scrub the fixture with a used toothbrush dipped in dry baking soda. Concentrate on the areas surrounding the orifices from which water emanates. Restore the flow of hot water to further expel any residual buildup. Repeat this process until all mineral deposits are eradicated.
Step 8: Polish With a Cloth
Employ a soft, lint-free cloth to polish the shower head, lending it a refined appearance. Thoroughly buff and dry it to eliminate water marks and restore the shower head's pristine allure.
If the shower head is detachable, simplify the cleaning process by submerging it in a bucket filled with distilled white vinegar. After soaking, follow the same cleaning steps outlined above before reattaching the fixture.
Read More